Resume a Natron Render After a Crash
A Natron render that dies halfway through an image sequence should not start again at frame 1….

A Natron render that dies halfway through an image sequence should not start again at frame 1. You also should not have to change the project’s first frame, or you will forget what the shot’s real start was. The Write node already knows how to skip work.
Leave the existing frames alone
On the Write node, turn off Overwrite. Render the same frame range again. Natron looks at the output folder, sees the frames that were written, and only creates the ones that are missing. The first frame of the project stays what it was. You do not edit the range, so you cannot forget it.
This only works if the output is one file per frame, such as a name ending in a frame number. A single movie file cannot be resumed this way. For a movie, render the image sequence to the end, then make the movie from the finished frames.
Check the last frame before you trust it
A crash can leave the last file half written. If Overwrite is off, Natron will see that file and skip it, and the bad frame stays in the shot. Open the last few frames. Delete any that are truncated or black, then render again. The hole you just made is the only thing Natron will fill.
